Heidenhain IK 5000 Addendum Uživatelský manuál stáhnout pdf (Strana 51)

IK 5000 QUADRA-CHEK 51

1.1 Operation

Profile3D Pass Only option

The Pass Only option on the Profile3D Measure window specifies that

the fitting algorithm terminates the fitting process when it finds a fit

that is within all specified surface tolerances. If the Pass Only option

is checked, and a tolerance has been specified for every surface on

which points have been probed, then the fitting algorithm will

terminate as soon as it finds a fit in which all probed points pass their

tolerance. If no such fit can be found then the fitting algorithm will

continue the process of fitting until it either finds the best fit it can or

none is found.

The Pass Only option is used to improve performance in cases where

time is a more important factor than accuracy. This is to be used when

a tolerance pass/fail is all that is required and not the exact amount of

the error. The amount of performance improvement varies depending

on how loose the tolerance is, and how close the part is to its nominal

form. The fitting of a part that fails its tolerance will not have any

performance improvement by using the Pass Only option.

To select the Pass Only option:

 Select Measure>Profile3D

 Select the Pass Only checkbox

 Click OK

Select the Pass Only checkbox

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 99 100

Žádné komentáře

Heidenhain IK 5000 Addendum Uživatelský manuál Strana 51