Heidenhain IK 5000 Addendum Uživatelský manuál stáhnout pdf (Strana 10)

10 1 Operation

1.1 Operation

Adjusting for change of part size

The location of features in a part under measure can change due to

change in size of the part. A program can adjust to measure the

features at the new locations by using the Prompt user for part scaling

function. This function prompts the user for a scaling factor that

repositions all features in a program. The new feature position is

calculated using the recorded feature position multiplied by the scaling

factor. The scaling factor is prompted for each time the program is run.

The Prompt user for part scaling function is located in the General tab

of the Program Properties dialog.

To prompt a user for part scaling:

 Start recording a program

 Double click Program Properties in the Program template window

 Click the General tab

 Check the check box next to Prompt user for part scaling and

then click OK

The operator will now be prompted to enter a scaling factor when the

program is run.

The size of the features under measure in the program are

not altered by the part scaling function, hence the system

will probe the features at the recorded size but new scaled

position.

Selecting Prompt User for Part Scaling

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 99 100

Žádné komentáře

Heidenhain IK 5000 Addendum Uživatelský manuál Strana 10