Heidenhain IK 5000 Addendum Uživatelský manuál stáhnout pdf (Strana 38)

38 1 Operation

1.1 Operation

Measuring rectangles

Precisely five probed points are required to measure a rectangle. The

five points must be located in an exact pattern, and can be probed in

either clockwise or counterclockwise order.

The correct pattern of points probed around the rectangle are:

 Two points evenly distributed along one long side

 One point on the closest end

 One point on the approximate center of the second long side

 The last point on the remaining end

Measurement results are shown in the Features template, Part View

window and Results window. The Results window shows:

 The feature identification number

 The number of points used in the measurement

 The length and width of the rectangle

 The angular orientation of the rectangle

 The coordinate location of the center of the rectangle

Only the rectangle shape and orientation are shown in the Feature

stamp of the Results window.

Clockwise probing order

Counterclockwise probing order

Probing a different pattern of points, or probing out of

either clockwise or counterclockwise order will result in

erroneous rectangle measurements.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 99 100

Žádné komentáře

Heidenhain IK 5000 Addendum Uživatelský manuál Strana 38