Heidenhain IK 5000 Addendum Uživatelský manuál stáhnout pdf (Strana 39)

IK 5000 QUADRA-CHEK 39

1.1 Operation

Profile3D measurements

Profile3D measurements compare probed part surfaces to nominal

part profiles from drawing or part data files. Probed surfaces and

nominal profile surfaces are compared in the Measure Profile3D

window.

The nominal part profile can be imported into the Measure Profile3D

window from a drawing file in .IGS or .STP formats.

As surfaces are probed, their points are displayed in the Measure

Profile3D window. When the desired surface measurements are

complete, a fit operation is performed. During the fit operation, the

system positions the probed data over the nominal profile and adjusts

the X, Y, Z and rotational orientation of the probed points to achieve

the best fit. Data points are shown as dots and form errors are shown

as whiskers.

Tolerances can be applied to Profile3D measurements as bilateral

limits or as unilateral pass/fail boundaries. Bilateral tolerances can be

distributed equally or unequally on opposite sides of a surface.

The form errors, the number of data points and tolerance pass/fail

results can be displayed in the Measure Profile3D window at the

conclusion of the Fit operation. Upon completion of the Profile3D

measurement, the Profile3D feature is listed in the Features template.

The form error of each surface point is listed in the Points Detail

template and can be visually inspected using the Profile3D Feature

Stamp.

Probed points shown in Measure

Profile3D window

Fit operation performed and form

error whiskers shown

Points Detail template Profile3D feature stamp

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 99 100

Žádné komentáře

Heidenhain IK 5000 Addendum Uživatelský manuál Strana 39